Why are 3D printers still stuck on stepper motors? Why haven’t we transitioned to servo motors with encoder feedback for positioning?
Is it just too cost prohibitive for the consumer-level? We would be able to print a lot faster and more accurately if we had position feedback on the axes. Instead we just rely blindly on the stepper not skipping any steps when we tell it to move, hoping for the best.
https://youtu.be/f5OHYZbrHjs?si=LruE_T63UnlSRWa0
This is as fast as I’ve seen for PLA while still retaining good quality. And he probably could go faster with more powerful motors or more of them.
Honestly, there’s going to be a hard peak to how fast a 3D printer can go, because physics. Unless we start running prints in a vacuum and start tuning local gravity….
That’s much much nicer. I’ve been looking at the bamboo x1c, its speed and quality is pretty amazing right out the box.
Here is an alternative Piped link(s):
https://piped.video/f5OHYZbrHjs?si=LruE_T63UnlSRWa0
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source; check me out at GitHub.