• cryptowillem@lemmy.ca
    link
    fedilink
    arrow-up
    2
    ·
    1 year ago

    Looking at the power supply listing, it says that it is USB-PD. It lists output as “5A @ 5.1V, 3A @ 9V, 2.25A @ 12V, 1.8A @ 15V”.

    I fully admit that I don’t understand USB-PD, though. Does the Pi have to support it too?

    • CmdrShepard@lemmy.one
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Yes, USB-PD requires a handshake confirming that both the charger and device are capable of using it.

      I didn’t look any further than the article listing the power supply as 5V5A so its good that it supports higher voltages, but really odd that it’d push out 25W at 5V as this is very demanding on the wiring since it has internal resistance which causes the voltage to drop with increasing length. The whole purpose of USB-PD is to up the voltage while reducing current to mitigate losses (and heat and wire thickness) and supply much higher wattage without having to use chunky wiring. This has been an issue with the Pi for quite a while which is why you always hear troubleshooting responses talking about having too small of a power supply. Now they’ve upped the power requirements while still using a 5V baseline. I did see the article mention that it has a voltage regulator capable of handling 20A of current so maybe it’s just poorly worded with regards to the official power supply.