• DokPsy@infosec.pub
    link
    fedilink
    arrow-up
    7
    ·
    1 year ago

    Might as well add some picos to scratch that itch. And the rabbit hole that micro controllers bring… next thing you know, your work desk is also a solder station, a hot air station, PCB design, circuit design, and you’ve got two extra diy printers in various state of being built/rebuilt

    I don’t have a problem, you have a problem

    • CobolSailor@lemmy.ml
      link
      fedilink
      arrow-up
      2
      ·
      1 year ago

      I started out the same way and now my desk is cluttered with partially completed projects and devices in various states of taken apart. But for me the fun part is learning something new along the project journey. The microcontrollers were a game changer due to their low cost. I’m not trying to fry them, but hey if I screw up who cares it was a couple bucks anyways.

      For circuits I design I’ve mostly been having them created overseas and I’ll solder on the components but I’m really curious about hacking a toaster into a refry oven or whatever their called and soldering surface mount components. Not that I need the small form factor or I’m making enough circuits to warrant trying to save on cost, I’m just curious and want to try haha. Gonna need a bigger desk…

      • DokPsy@infosec.pub
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        Honestly, get the flux and a hot air station instead, imo. Then again, I prefer being able to have control over where the heat is going instead of reflowing everything at once