• TwilightKiddy@programming.dev
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    You don’t need to check female port orientation, it’s always the same, pins inside the port are looking at the board the connector is soldered to. Of course, unless manufacturer decided to do something funny, but no standard is protected from that.

        • Belazor@lemmy.world
          link
          fedilink
          arrow-up
          3
          ·
          1 year ago

          I’m not sure I understand your point. You can make a USB stick that fries your hardware too, that doesn’t mean Kingston is going to make all of their pen drives fry your hardware.

          Is this some kind of “acshully I’m technically correct because it’s theoretically possible” thing?

          • TwilightKiddy@programming.dev
            link
            fedilink
            arrow-up
            1
            ·
            edit-2
            1 year ago

            The point is that manufacturers can screw up standards and being a symmetrical connector does not cure idiocy in the heads if some people. Yes, the standard explicitly says you have to short opposing data lines for 2.0, but that does not mean everybody will comply with it. (The author of the video is not an idiot, they just demonstrated that it’s possible)

            The most common example of this I can think of right away is male-male connectors with type A USB. They are explicitly prohibited, yet many manufacturers create them and use in their products.

            That’s why I said that no standard can protect you, you’re just relying on people not being dumb and actually reading the paper you published.

            • Belazor@lemmy.world
              link
              fedilink
              arrow-up
              1
              ·
              1 year ago

              Right, I see your point, thank you for clarifying :)

              That being said, unlike the male-to-male example, where I personally don’t understand why the spec prohibits it, I think it’s pretty obvious why consumers want USB-C. The Internet is awash with memes about inserting USB three times, etc.

              I think there’s a vast difference between “why is male-male banned? Heck it, I’ll create one as it serves our use case” and “I’m going to negate the only consumer-facing advantage USB-C has for no real reason”. Yes I know C has many other benefits but the common denominator doesn’t care about any of that.

              • TwilightKiddy@programming.dev
                link
                fedilink
                arrow-up
                1
                ·
                edit-2
                1 year ago

                If you have two devices with female USB A ports that both provide power via said ports, connecting them with male-male cable will create a short circut. Best case scenario: a current protecting fuse breaks the circuit. Worst case: both processors on both motherboards are dead. Better not think you can connect two computers with that evil thing. That’s why type B connector exists, it’s about the same size, but it never connects to a port that provides power.