Turned on retraction speed to 11 and i guess it wore down the filament at one part but then managed to push it after some 10 minutes of spaghetti 👌

  • 𝒍𝒆𝒎𝒂𝒏𝒏@lemmy.oneEnglish
    8·
    1 year ago

    Anyone aware if that be re-melted or recycled back into filament, or is it pretty much done for?

    If I had a 3D printer this would be nightmare fuel after waiting X hours for the print to complete lol

    • cynar@lemmy.worldEnglish
      11·
      1 year ago

      In theory, you can remelt. Unfortunately, the practicalities mean it’s not viable. Each remelt cycle degrades the plastic itself, so you can only put 20% or so ‘old’ plastic into the mix. Combined with the game of plasticisers (to remove brittleness) and reliable forming, even commercial systems struggle, let alone home ones.

      If environmental concerns are the issue. It’s best to print in uncoloured PLA filament. PLA is corn starch based, and decomposes in a bio reactor environment (it rots quickly in an industrial composter).

      As for speed. They are getting impressively fast. A calibration cube takes around 20 minutes, though less than 5 minutes is possible. My machine is effectively fire and forget. They mess around while you are tuning them in, but once you have a good calibration, they now tend to hold it well. You’ll sit there watching it in fascination for the first few months, but that wears off.

    • FredericChopin_@feddit.ukEnglish
      8·
      1 year ago

      You kinda get used to them failing.

      Part of the reason my printer just sits there not being used, aside from I collect hobbies for fun, is that it’s a nightmare levelling the bed and getting things dialled in.

      Resin printers don’t have these issues but it depends what you’re printing I guess.

      • Dept@lemmy.sdf.orgEnglish
        2·
        1 year ago

        resin printers have the slight issue of being a chemical hazard and requiring PPE.

      • TheHarpyEagle@lemmy.worldEnglish
        1·
        1 year ago

        Getting an auto leveler was a game changer for me. I still manually level the bed and check the Z offset every two months or so along with other maintenence, but I’ve gone on week long printing sprees without touching the bed springs once.

          • chris@l.roofo.ccEnglish
            1·
            1 year ago

            A few tips that made my prints much better:

            • Check if your rollers are tight enough. None of the axes should wobble if you pull on them
            • Use a PEI sheet for printing
            • Clean the PEI Sheet with Soap and Water at least once
            • Clean with IPA after every print
            • Don’t touch the print bed. The oil on your skin really doesn’t help with sticking.
            • Get yourself a metal feeler gauge with 0.2mm. Level your bed heat nozzel and bed to your normal print temp an then move the nozzel 0.2 mm above the bed. Adjust your Z Offset until you can get the metal gauge undr the nozzle but still feel it touching. that should be your perfect height
            • If you still have problems try all the steps here one after another: https://teachingtechyt.github.io/calibration.html

            I used to have a lot of problems with parts lifting up or my prints being unclean but since I did this my prints look great and stick to the bed.

    • spckls@lemmy.worldOPEnglish
      2·
      1 year ago

      You get used to that being a possibility with every print. That’s why you should do everything in your power to have your printer always in shape and operational, although sometimes it will happen no matter what!

      Unfortuneatly, this is just waste, straight to the bin.